We’re Hiring for Southern California Territory Rep

BlogBy James Yundt February 19, 2021

We’re seeking a qualified candidate to fill our Southern California Territory representative position.

Visit Roofmaster Products at the 2020 Virtual Western Roofing Expo!

BlogBy James Yundt June 24, 2020

COVID-19 may have prevented us from meeting up in person, but the 2020 Western Roofing Expo will continue! Come explore the virtual expo and see us in Booth 523 with this free expo pass, available July 1-15, 2020. See the all new Ol’ Sparky Generator, and the rest of our on deck equipment, tools and…Details

COVID-19 Update

BlogBy James Yundt March 24, 2020 Leave a comment

To Our Valued Customers, Roofmaster has made the decision, for your health and ours, to close our showrooms to the public due to the spread and impacts of COVID-19. While our showrooms are closed, we are still open for business! Our transportation partners are still operating, so UPS and LTL shipments are still shipping. For…Details

Come see Roofmaster in booth 113 at the 2019 WRE in Las Vegas!

BlogBy James Yundt May 3, 2019 Leave a comment

Use this pass for free admission to the exhibit floor! June 10-11, 2019, at the Las Vegas Paris Convention Center See the new Leister Uni-Drive 500 in action!

Are you servicing your safety equipment?

BlogBy Dan Dallenbach November 10, 2017 Leave a comment

Recently we assisted a contractor that had a large development job with Camp Pendleton in San Diego. Because the work being conducted was on the military base, certain governmental procedures had to be observed while performing the work, especially pertaining to safety. Our extensive background and knowledge in safety products saw the contractor use the…Details

The importance of training on new equipment

BlogBy Pat Amicucci October 27, 2017 Leave a comment

My job as a salesperson does not end after I receive a PO. Training and customer service are a large part of the service that I offer my customers. According to this NRCA article, roofing contractors are investing in more technology to help improve equipment safety. Technology alone is not the answer; technology combined with…Details

Don’t Cut Corners on Safe Rooftop Material Loading

BlogBy Arik Moe September 22, 2017 Leave a comment

Roofing contractors are being challenged on a daily basis. I notice firsthand that contractors are trying to be more competitive by trimming production times, managing quality control, and adhering to strict safety requirements. This effort to complete a job quickly while maintaining a safe job site at times can be overwhelming and conflicting to a…Details

Proper use of your “Rattle Can” aka Aerosol Spray Paints

BlogBy James Yundt September 18, 2017 Leave a comment

Growing up in Texas everyone knew aerosol spray paints by the nickname of “Rattle Cans.” That’s because the directions told you to shake the can up to mix the ingredients (pigments, solids, solvents) before spraying. Inside each can is a plastic ball the helps to mix the ingredients together before spraying that makes a noise…Details

Get Your Money’s Worth with Fall Protection

BlogBy Jeremy Martin September 15, 2017 Leave a comment

I spend a lot of time on the road meeting with contractors onsite, either delivering goods or following up to make sure they are satisfied with their products. When I drive by a job site, I always look at the workers on the roof to see if they are wearing proper fall protection gear. Too…Details

Snips; Not Just for One Hand or the Other

BlogBy John Davis September 1, 2017 Leave a comment

Snips are an essential tool for the roofing industry. Whether the snips are used for vinyl or metal siding, metal flashing, asphalt shingles, or gutters, these tools can be found on just about every roof deck. Last week I was speaking with a buyer about the lineup of Midwest snips that Roofmaster carries. While discussing…Details

ROOFMASTER PRODUCTS

Blog